Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
INSTALLATION
& ASSEMBLY
Wall Mounted Installation
Fireplaces
MODEL
LEDFP-
50 | LEDFP-60 | LEDFP-72
LEDFP-40/50/60
Wall Bracket
Illustration
LEDFP-72
Wall Bracket
Illustration
Due to the many different materials used on
different walls, it is highly recommended that you
consult your local builder before you install this
appliance on the wall.
1. Select a location that is not prone to moisture
and is located at least 36" (914mm) away
from combustible materials such as curtain
drapes, furniture, bedding, paper, etc.
2. Have two people hold the appliance against
the wall to determine the final location
3. Place unit face down on a soft, non-abrasive
surface. Remove the bracket from the back of
the unit by removing the screws
4. Mark out location, then mount the bracket(s)
onto the wall using the supplied screws. This
bracket MUST have the hooks facing upward
and be level. It is strongly recommended that
the mounting bracket be screwed into the
wall studs where possible. If the wall studs
cannot be used, ensure that the supplied
plastic anchors to affix the bracket to the wall
and the bracket is adequately secured
5. With the wall mounting bracket installed,
have two people lift the appliance up and
insert the two hooks
6. Check the appliance for stability ensuring that
the bracket will not pull free from the wall
Hard Wiring Installation
Hard Wiring Connection
If it is necessary to hard wire this appliance, a qualified electrician MUST remove the
cord connection, and wire the appliance directly to the house hold wiring.
This appliance MUST be electrically connected and grounded in accordance with local
codes. If hard wired, in the absence of local codes, use the current CSA C22.1
CANADIAN ELECTRICAL CODE in Canada or the current ANSI/NFPA 70 NATIONAL
ELECTRICAL CODE in the United States.
Cover Plate
Fig. 1
Fig. 2
Screws
Screws
Hook
Hook
