5.3
Setup and operations
1 START UP
After flip the main power switch at the back of the unit from 0 to I,the main power indicator on the front
panel will blink red (approx. 4 sec ) and blue when ready for operation.
3 BRIGHTNESS SETUP AND STANDBY
If you press the button, the red light will blink.
The unit is waiting a second press or not during 4 seconds.
If you press a second time, the red light will stop to blink and you will go to brightness configuration.
Piloted mode
: after this laps time of 4 seconds, the unit will returned in main mode.
Manuel mode
: after this laps time of 4 seconds, the unit will go to standby mode (switching off the
blue light).
4 BRIGHTNESS SETUP
The default brightness level loads automatically.
In this menu, you can choose between 8 different levels to set the light brightness.
Simply pressing the button to navigate between levels.
To confirm the value chosen and return to the main screen, wait 8 seconds without press the button.
The brightness level will be register in ROM automatically. You shouldn't set the level every restart
the unit.
5 STANDBY
In pilot mode
, you can't to put the amp in standby mode manually. The signal will be send by a
preamp correctly « câbler ».
Red lights blink approximatively 35 seconds to discharge of voltage capacitors. The button has no
effect during this laps of time.
Wake up the unit, just press the button.
6 WAKE UP
The main power indicator on the front panel will blink red (approx. 4 sec ) and blue when ready for
operation (main mode).
7 PSU ERROR
In case of problems, the amplifier goes into error mode.
Red light is blinking very fastly. If this were to happen, switch off the main power. Wait 5 minutes
before try again to switch on the amplifier..
If this problem persists please contact your dealer or distributor as soon as possible.
ORPHEUS MEDIA SARL
– Avenue des Sciences 3 – 1400 Yverdon-les-Bains - Phone : +41 24 423 90 88 – Fax : +41 24 424 90 89
Email :
– Website: www.orpheuslab.com
9
