Orion Sentry HP, Быстрый старт

Страница: 5 / 12

Bulletin #: V113018-04
Issue Date: November 30, 2018
Orion Packaging Systems * A division of Pro Mach
4750 County Road 13 NE Alexandria, MN 56308
(800) 333-6556
http://www.orionpackaging.com/parts-and-service/manuals/
Page 5 of 12
Sentry HP/LP
Quick Start Guide
Machine Installation
Note : The structural frames of the machine have to be placed on a leveled floor. The base deviation
from vertical must not exceed 1/4" on the distance of 10 feet (angle: 0 degrees 6').
1. Move the wrapper into its final position.
2. Any wiring that has been disconnected to facilitate transport is marked with a number located on
the junction box to which the wiring must be reconnected. Any wire run that appears too short or long
may indicate that the position of the mechanical components is incorrect. Verify the status of all
assemblies before proceeding.
Connect Power

Make sure the MAIN DISCONNECT switch on the wrapper’s panel is set to the OFF position.

Orion Packaging insists that a dedicated circuit is used for this wrapper. Extension cords are not
allowed and can void your warranty.

Plug the machine into the 115 VAC/ 60 Hz/ 1 Phase / 15 Amp outlet.
Power Up / Boot Up

After verifying that the area around the machine is safe, you may apply power to the machine by
turning the MAIN POWER switch to the ON (Arrow Up) position.

Please allow 30 seconds before pressing any buttons to allow the program to boot up.

Release the E-stop button.

Press and release the Start button once to gain Control Power.

Initializing will display in the information banner momentarily.

See jogging on the next page to begin testing your machine.