- 6 -
Installation and use manual for OT-U250PP & OT-U500PP
The screw in lower left part of bag compartment’s door is longer than the others and its removal activates
the tamper output. After the screw has been positioned correctly, the machine emits 4 beeps and
deactivates tamper output.
Main Power supply
7.
220V-230VAC power source supplies energy only to the heating system. The electronic board and the bag’s
pump are supplied from the alarm system and batteries. The heating element is of 0,3KW, at the very
beginning power consumption is about 250W and in some minutes it goes down reaching average
consumption is about 40W - 60W.
Do not use inverter or UPS if you are not sure that they generate a true sine wave, not a rebuilt
one. Ask please to the UPS manufacturer the correspondence of such features before
proceeding with the connection.
•
The max current to be considered for the system is 4A
•
The connection to the 230V electricity grid must be performed by a qualified technician.
•
Connect the equipment to the electricity grid only after you have completed the installation.
•
It is necessary to connect the ground terminal.
•
The system must be connected to the mains trough on automatic switch:
(automatic switch, curie C, with Ih= 10 A and Idif= 30 mA,...) with breeching capacity based on the
assumed fault current of the fogging system in the sampling point.
PLEASE NOTE THAT, AS ALL POWERED EQUIPMENT FROM THE ELECTRICITY GRID REQUIRING
INSTALLATION, IT IS SUBJECT TO COMPLIANCE WITH RULES OF THE COUNTRY IN WHICH IT IS INSTALLED
For section and types of wires, fuses, suitability of materials to installation sites etc..
IF YOU NEED TO REPLACE THE FUSE, USE ONLY FUSE WITH THE FOLLOWING SPECIFICATIONS:
CERAMIC BODY FILLED WITH QUARTZ, REF. STD. EN60127-2-3/DIN41660 3,15AH (EXAMPLE OMEGA
GT520231)
