9
Installation and User’s Guide
http://www.orionimages.com
7300 Bolsa Avenue, Westminster CA 92683 / Tel: 714-766-6300 / Fax: 714-766-6310
pg9
Features
2.3 Griplate™ Washer Installation
Griplate™ Washers are designed to accommodate the
various M4, M5, M6 and M8 hole sizes required by flat panels.
z
For Griplate™ installation, the dimples must be facing
the flat panel for the lower mounting points. For the upper
mounting points, the dimples must be facing away from the
flat panel.
z
Do not place excessive pressure on the back of the fl at
panel, as this may damage your fl at panel.
z
The Griplate™ Washer must be installed between the
head of the mounting screw and the mounting bracket as
shown.
Does your flat panel have:
z
Recessed mount points?
z
Uneven mount points?
z
A curved back?
z
Any obstruction near the mount point?
If
Yes
, you must install nylon spacers. Remove the mounting
brackets, Griplate™ washers, and mounting screws from the back
of the fl at panel. Proceed to the
“Nylon Spacer Installation”
section..
Nylon Spacer Installation
Nylon spacers allow you to attach the mounting bracket to
flat panels which have recessed or uneven mount points.
Each nylon spacer will add distance between the mounting
bracket and your flat panel.
z
The nylon spacers must only be installed between the
mounting bracket and your fl at panel. The nylon spacers
will fit M4, M5, M6 and M8 screw sizes.
Proceed to the
“Flat Panel Installation”
section.
Mounting Screw
Griplate™ Washer
Mounting Bracket
Flat Panel
Nylon Spacer
Mount Point
M8
M6
M5
M4
