Orion 2004-8899999, Инструкция по эксплуатации

Страница: 16 / 42

LOADING THE FILM
The film roll can be loaded on the carriage mandrel from either end of the
roll. When using tacky film, please verify that the inward tacky surface of the
film is inward on the load.
1. Disconnect power (turn off power switch).
2. Swing up the top mandrel spool.
3. Put the roll of film on the bottom mandrel.
4. Install the top mandrel on top of the roll to prevent upward movement.
5. Pull the handle marked PULL TO OPEN to open film distributor cradle.
6. Pass the roped tail of the film through opening (as shown on the film quick
threading pattern DWG. # 418180 Fig.1).
7. Close the film distributor cradle by pushing bar marked PUSH TO CLOSE.
8. When the film feeding is completed (fig. 2) – turn the power switch on.
9. Peel off the first few winds of the film (multistrech will run due to
displacement of the dancer roller) and fix the film end onto the load.
The system is now ready to begin the first wrapping cycle.