Orion 2004-8899999, Инструкция по эксплуатации

Страница: 12 / 42

FILM TENSION
Film tension may be adjusted using the film tension control knob. It has a range of tension
from 0 to 10 (0 to 4 the low range, 4 to 8 the most useful range for most of the films used by
our customers, 8 to 10 as a very high range which may break some films).
CARRIAGE SPEED
The carriage speed potentiometer control can be used to control the amount of overlap the
film will have during the wrap. The potentiometer has settings from 0 to 10, the higher
settings being the fastest. High settings mean less film overlap because of faster carriage
speed and low settings mean more film overlap because of lower carriage speed.
TOP WRAPS 1,2,3...9
Three-position switch controls the number of wraps that may be applied on the top of the
load. The machine is preset RANGE # 1 (top wraps: 1 or 2 or 3). To change the values of
wrap see TOP & BOTTOM WRAP COUNTS CHANGE.
BOTTOM WRAPS 1,2,3...9
Three-position switch controls the number of wraps that may be applied on the bottom of the
load. The machine is preset with RANGE # 1 (bottom wraps: 1 or 2 or 3) which may be
applied. To change the values of wrap see TOP & BOTTOM WRAP COUNTS CHANGE.
TOP & BOTTOM WRAP COUNTS CHANGE
The Top & Bottom Wrap Selector Switches have three (3) ranges of wrap counts and
operate independently of each other.
Range #1 Wrap values of 1 - 2 - 3
Range #2 Wrap values of 4 - 5 - 6
Range #3 Wrap values of 7 - 8 – 9
For the selection of any of these ranges for top and bottom wraps please do as follows:
Before proceeding ensure that machine is in MANUAL, STANDBY MODE (machine is
powered on and all machine manual functions are enabled) Press the STOP (red) Button
Set the Top and Bottom wrap count selector switch to the position corresponding with the
desired count range.
1 = Range #1
2 = Range #2
3 = Range #3
Press the START (Green) pushbutton and maintain for approximately 12 seconds. Pull the
STOP (Red) pushbutton out. Perform standard machine reset procedure by double push-
pull operation of the red mushroom stop button. At this point machine is ready and new
preset values are loaded.