APPENDIX C
Aux1 Remote Energ.
The output Aux1 status was changed from de-energized to energized through a remote
command.
Aux2 Remote Energ.
The output Aux2 status was changed from de-energized to energized through a remote
command.
Aux3 Remote Energ.
The output Aux3 status was changed from de-energized to energized through a remote
command.
Aux4 Remote Energ.
The output Aux4 status was changed from de-energized to energized through a remote
command.
Aux5 Remote Energ.
The output Aux5 status was changed from de-energized to energized through a remote
command.
Aux6 Remote Energ.
The output Aux6 status was changed from de-energized to energized through a remote
command.
Aux7 Remote Energ.
The output Aux7 status was changed from de-energized to energized through a remote
command.
Aux8 Remote Energ.
The output Aux8 status was changed from de-energized to energized through a remote
command.
Default Sp. Loaded
In case of internal fault, the VFR has been reset back to default setpoint values.
Setpoint Stored
A setpoint modification took place. Consecutive changes in the Setpoint section are
stored under the same event. Following a minute after the last modification, a new
event will be generated.
Setpoint Discrepancy
The values set by the user in the Setpoint section, generated a discrepancy (e.g.: verify
the values of Threshold and Reset that could generate a protection malfunction
–
Reset Level > Threshold Level in Overvoltage1 or Reset Level < Threshold Level in
Undervoltage1).
See [Troubleshooting]
BLE Failure
Internal fault occurred in the Bluetooth module.
BLE Module Tested
The BLE test was executed by the user.
Password Changed
The user changed the password.
Model Changed
The version model of the VFR was upgraded.
Calibration Data Lost
The VFR has lost the Calibration data values.
Status Lost
Following a restart of the VFR, the unit is not capable of reaching the same status
present before it was restarted.
Aux Power Lost
The VFR was powered off.
Aux Power Restored
The VFR was powered on.
ADC Failure
Internal fault occurred in the digital analogic converter.
Flash Busy
The internal flash memory was not available during the reading/writing operations.
Out Of Service
Out of service
conditions occurred.
Communication Error
Internal Fault occurred in the communication between two microcontroller.
Digital Input 1 Closed
The status of Digital Input 1 was changed from Open to Closed.
Digital Input 2 Closed
The status of Digital Input 2 was changed from Open to Closed.
Digital Input 1 Open
The status of Digital Input 1 was changed from Closed to Open.
Digital Input 2 Open
The status of Digital Input 2 was changed from Closed to Open.
