TES-3082GT-M12-BP1 User’s Manual
ORing Industrial Networking Corp
72
applicable in half-duplex only.
OutPause
The number of good Flow Control frames sent.
InPause
The number of good Flow Control frames received.
Multiple
The total number of successfully transmitted frames that
experienced more than one collision. This counter is
applicable in half-duplex only.
Undersize
Total frames received with a length of less than 64 octets
but with a valid FCS.
Fragments
Total frames received with a length of more than 64 octets
and with a invalid FCS.
Oversize
Total frames received with a length of more than MaxSize
octets but with a valid FCS.
Jabber
Total frames received with a length of more than MaxSize
octets but with an invalid FCS.
InMACRcvErr
Total frames received with an RxErr signal from the PHY.
InFCSErr
Total frames received with a CRC error not counted in
Fragments, Jabber or RxErr.
Collisions
The number of collision events seen by MAC not including
those conted in Single, Multiple, Excessive or Late. This
counter is applicable in half-duplex only.
Late
The number of times a collision is detected later than 512
bits-times into the transmission of a frame. This counter is
applicable in half-duplex only.
5.1.14.5
Port Monitoring
Port monitoring function supports TX (egress) only, RX (ingress) only, and both
TX/RX monitoring. TX monitoring sends any data that egress out checked TX
source ports to a selected TX destination port as well. RX monitoring sends any
data that ingress in checked RX source ports out to a selected RX destination port as
well as sending the frame where it normally would have gone. Note that keep all
source ports unchecked in order to disable port monitoring.
