RGS-PR9000 Series User Manual
ORing Industrial Networking Corp
14
3.2.4
Power Module
Each RGS-PR9000 series switch supports maximum two power modules. Follow the steps
bellows for installation.
Step 1: Switch off the power of the switch.
Step 2: Insert the modules in Power 1 and 2 slots respectively.
Step 3: Switch on the power of the switch
3.3 Wiring
WARNING
Do not disconnect modules or wires unless power has been switched off or the
area is known to be non-hazardous. The devices may only be connected to the
supply voltage shown on the type plate.
ATTENTION
1. Be sure to disconnect the power cord before installing and/or wiring your
switches.
2. Calculate the maximum possible current in each power wire and common
wire. Observe all electrical codes dictating the maximum current allowable
for each wire size.
3. If the current goes above the maximum ratings, the wiring could overheat,
causing serious damage to your equipment.
4. Use separate paths to route wiring for power and devices. If power wiring
and device wiring paths must cross, make sure the wires are
perpendicular at the intersection point.
5. Do not run signal or communications wiring and power wiring through the
same wire conduit. To avoid interference, wires with different signal
characteristics should be routed separately.
6. You can use the type of signal transmitted through a wire to determine
which wires should be kept separate. The rule of thumb is that wiring
sharing similar electrical characteristics can be bundled together
7. You should separate input wiring from output wiring
8. It is advised to label the wiring to all devices in the system
