Machine Operation
After fitting the brush or the pad driver (IF NEITHER IS FITTED DAMAGE CAN BE CAUSED TO THE FLOOR IF THE MACHINE IS
USED).
Adjust the handle to a comfortable position.
Rotate the wheels up off the floor.
Check that the electric cable is plugged in and that the indicator light on the switch box is lit. Make sure the cable is away from the
brush
Push in the safety lock button and lift the switch lever.
Switch on the Vacuum motor.
Machine Movement
The machine moves by tilting the handle up or down. Lift handle up and the machine moves to the right, handle down and the machine
moves to the left. Holding the machine handle in a neutral position and the machine will be stationary. The machine is controlled through
Maintenance and storage
1. Always empty the filter bag at the end of a shift even if the bag is not full.
2. Make sure the bag support stand is in position at the bottom of the canister under the filter bag (see
Diagram 18).
N.B.
This support stand
must always
be in position to maintain vacuuming performance. The
secondary filter disc must be used and sits on top of the bag support.
3. Check the filter bag for holes or tears. Replace the bag if torn or damaged. Failure to do so could result in
motor damage.
4.
The cleaner the filter bag is kept, the better the vacuum performs.
The filter bag can be cleaned by
turning the bag inside out and using a soft banister brush to remove dust or use a vacuum cleaner.
5.
DO NOT WASH THE FILTER BAG.
6. Consider using a disposable liner bag—it will serve as an extra filter and keep the filter bag clean.
1. Unplug the electric cable when the machine is unattended or not in use, or when
cleaning the machine or changing the brush or pad.
2. Wind the electric cable from the machine end to prevent the cable from twisting. Wind the cable around
the handle and the cable hook. While winding the cable have a rag in one hand to clean it and check for
damage.
3. Replace the electric cable if there is any damage or badly kinked. The cable must be replaced with the
manufacturer’s original cable by an authorised dealer.
Keep the skirt clean of debris and dirt and check the skirt chute opening is clear of
debris. Also check that the hose is clear of debris.
Replace the skirt if torn or damaged.
Do not store the machine with the brush attached as this can cause brush damage and
Bouncing of the machine when in use.
Replace the brush when worn or the bristles are flattened out. The brush performs best on the ends of the
bristle.
Excessive amounts of floor finish or dirt collected on the brush can cause drag and overload the machine.
Keep the brush and pads clean after use.
Electric Cable
Filter Bag
Skirt Maintenance
Brush Care
