5. Electric Cable Maintenance
Unplug electric cable from the wall socket and wind the cable
starting from the machine end of cable
- not the plug end.
This will help prevent the cable from twisting and causing premature failure. Wind the
cable around the hook and the handle (See Picture 11 & 12). Check for any
damage to the cable
while
winding it. If there is any damage do not use the machine until the cable is replaced.
Make sure the cable is looped through the cable restraint (See Picture 13).
Picture 13
Picture 11
6. Motor Thermal Overload Switch and Vacuum Motor Thermal Cut out
The Brush motor is fitted with a thermal overload to protect it. This switch will activate if the motor gets over loaded, after
allowing time for the motor to cool, the overload switch can be reset by pushing the button (See Picture 14). Motor overheating is usually
caused by an extension cord or the wrong brush or pad for the floor surface.
The Vacuum motor is protected by an
automatic
thermal cut out and will
reset itself
when the motor cools down. The cause for
overheating of the vacuum motor is usually attributed to a blockage in the hoses or the filter bag needs cleaning or replacement.
Picture 14
Fitting of the Lid
(see Fig. 5)
The lid needs to be fitted so that the elbow (where the hose fits on) is in the correct position to engage the hose. To
fit the lid, make sure the filter bag is located inside the canister so that the black ring on the filter bag is flush with the
top of the canister. Then locate the lid over the filter bag ring so that the tabs on the lid are in line with the indents on
the canister. Push lid firmly down so that tabs lock into position. Then fit hose by inserting the hose cuff and turning
counter clockwise to a locked position.
ALWAYS MAKE SURE
that the bag support and the white filter disc are fitted under the filter bag. (See Diagram 18).
7.
Removal of the Lid
First remove the hose attached to the lid by turning Clockwise (See Picture 15 & 16). To remove the
lid, place a finger under
the tab in front
of the unit (see picture 17). Pull tab out and up slightly to dis-
engage tab from the body and to clear the black ring on the filter bag. Grab the lid then pivot back and
lift up.
Bag Support
Diagram 18
Picture 17
Picture 15
Picture 12
Picture 16
