Orientalmotor US2 Series, Руководство по эксплуатации

Страница: 17 / 32

Operating
−
17
−
5.2 To adjust the motor rotation speed
Operation switch
Setting dial
Variable speed range
50 Hz: 90 to 1400 r/min
60 Hz: 90 to 1600 r/min
Setting the operation switch to the "RUN" side causes the motor to rotate. Setting the
operation switch to the "STAND-BY" side causes the motor to stop. The speed while the
motor is rotating can be adjusted with the setting dial.
Turning the setting dial slowly
When the setting dial is turned to the right, the rotation speed accelerates by 1 r/min
increments. When the setting dial is turned to the left, the rotation speed decelerates by
1 r/min increments.
The display blin
k
s at this time.
Turning the setting dial quickly
The amount of the rotation speed change increases.
When the setting dial is pressed, the rotation speed is determined, and the display
changes to a lighting state.
The actual rotation speed is indicated while the display is lit.
•
The rotation speed can be set up to 1600 r/min. However, when the product is used at 50 Hz, the motor cannot be operated
at the speed exceeding approximately 1420 r/min.
•
The rotation speed can be set regardless of whether the motor rotates or stops.
5.3 Switching the motor rotation direction.
The motor rotation direction can be changed with the rotation direction switch.
Rotation direction
switch
FWD
REV
Rotation direction when setting to "FWD" Rotation direction when setting to "REV"
The rotation direction of the gearhead output shaft varies depending on the gear ratio of the gearhead.
Change the rotation direction switch according to the gear ratio of the gearhead.
Note To change rotation direction of the motor, wait until the motor completely stops. If the rotation direction is
switched while the motor is operating, it may not change, or it may take a long time to change.
Parallel shaft • combination type
Gear
ratio
6 W, 15 W, 25 W 5 to 25, 150 to 360 30 to 120
40 W, 60 W 5 to 18, 120 to 300 25 to 100
90 W 5 to 15, 75 to 180 18 to 60
Rotation direction
*
FWD
REV
REV
FWD
Right angle • geared type
Gear ratio
5 to 120 150 to 240
Rotation
direction
*
•Hollow shaft
•Solid shaft ・
Right shaft
•
Solid shaft
・
Left shaft
•Hollow shaft
•Solid shaft ・
Right shaft
•
Solid shaft
・
Left shaft
FWD
REV
FWD
REV REV
FWD
REV
FWD
*
When the rotation direction switch is set to "FWD," the motor rotates in the forward (FWD) direction in the figure above.
When the rotation direction switch is set to "REV," the motor rotates in the reverse (REV) direction in the figure above.