Button Definition as below:
(TABLE3
)
Current Status
Function (Press button and
release it in 2 seconds)
Function (Press button and
hold it for 3 seconds
minimum)
Normal Operation
、Hush State、Low Battery Test Local
Hush
Local Alarm
Locate All
Hush
Remote Alarm
Locate All
Hush
Locate Alarm
None Local
Hush
Function Definition as below:
Test:
This function can simulate the alarm signal, and lead the device to Local Alarm Status (refer to
TABLE2
). The simulated alarm signal will disappear after 15 seconds.
Locate
：
This function can lead the device to Locate Alarm Status (refer to
TABLE2
).
Local Hush
： This function can lead the device to Hush Status (refer to
TABLE2
).
（Only to the device）
All Hush
： This function can lead all the devices which are in the same ID to Hush Status (refer to
TABLE2
).
TESTING THE SMOKE ALARM
1.
Test each smoke alarm to be sure it is installed correctly
and operating properly.
2.
The push-to-test button accurately tests functions. Do
not use an open flame to test this smoke alarm. You
may ignite and damage the smoke alarm or your home.
3.
Test smoke alarms weekly and upon returning from
vacation or when no one has been in the household for several days.
4.
Stand at arm’s length from the smoke alarm when testing.
5.
Press the test button and release it in 2 seconds
，the smoke alarm will sound a loud beep. The other
devices in same ID should sound a loud beep in 8 seconds. The alarm will stop sounding after 15s.
6.
If smoke alarm does not sound, please retest the smoke alarm.
DANGER:
If the alarm sounds, and smoke alarm is not being tested, the smoke alarm is sensing smoke.
THE SOUND OF THE ALARM HORN REQUIRES YOUR IMMEDIATE ATTENTION AND ACTION.
NUISANCE ALARMS
When the nuisance alarms occur, press the test/hush button and hold it for 3 seconds minimum which can lead the
device to be in Hush status (refer to
TABLE2
) for 10 minutes. If, when the alarm goes off, there is no sign of
smoke, heat or noise to indicate that there is a fire, you should get your family into a safe place, before you start
investigating.
Check the house carefully in case there is a small fire smoldering somewhere. Check whether there is some source
of smoke or fumes, for example cooking fumes being drawn past the smoke alarm by an extractor.
If there are frequent nuisance/false alarms it may be necessary to re-locate the device away from the source of the
fumes. If for some reason the alarm continues to sound without smoke or heat being present (due to insect
infestation or contamination build-up for example) the units can be silenced by disconnecting the mains power
and removing the unit. If cleaning the alarm does not correct the problem it can be returned to the manufacturer
