5
GETTING STArTED
3 GETTING STARTED
3.1 Baby unit power supply
(1) Connect the small plug of the power adaptor to the baby
unit and the other end to the electrical mains power
outlet.
(2) Switch the unit to the ON position. The power LED will
light up.
(3) To switch off the baby unit, slide the power switch to
OFF position.
Only use the AC power adaptor supplied with the product
as other power adaptors could damage the product. This
product is designed for indoor use only.
!
Warning
3.2 Connecting and aligning the baby unit
Position the baby unit with a minimum distance of 1m to
other electronic devices, otherwise there is a risk of mutual
disturbance. Point the upper section of the baby unit towards
the baby or object you want to monitor. Check that the baby or
object is suitably displayed on the parent unit screen. Ensure
the antenna is extended vertically for optimum range.
3.3 Parent unit battery installation
(1) Insert the battery pack into the parent unit ensuring the
contacts match.
(2) Close the battery compartment.
(3) Press and hold <Power> key for 2 seconds to switch on
the parent unit. It will take a few seconds for the unit to
start up. The power LED will light up.
(4) If press and hold <Power> key for 2 seconds again to
turn OFF the parent unit.
NOTE:
When the battery level is low, the power LED will flash slowly.
3.4 Charging the Parent unit
(1) Connect the small plug of the power adaptor to the
parent unit and other end to the electrical mains power
outlet.
(2) If the unit is powered off, the power LED will turn on
steadily.
(3) If the unit is powered on, the battery level indicator will
change to indicate the battery charging status.
NOTE:
YOU MUST INITIALLY CHARGE THE BATTERY FOR 12-14
HOURS BEFORE USE. THIS IS IMPORTANT TO MAINTAIN
ADEQUATE BATTERY PERFORMANCE.
OR013248 - Amend SC850 User Guide_01-26-16.indd 5
2016/1/28 8:37:48