16
09.09/WE
ORGAPACK OR-T 400
Fig. 6
1
AUTO
MAN.
SOFT
AUTO
MAN.
SOFT
+ / -
+ / -
1
Fig. 8
Fig. 7
1
H-2386
1-800-295-5510
– Take the tool in the right hand and lift the rocker lever
(6/1) towards the handle.
– Slide the straps, one on top of the other, into the tool
up to the stop.
The strap lead is now approximately 5 cm (2“)
beyond the tool.
– Release the rocker lever.
– Press the tension button (7/1) until the preselected
strap tension is reached.
The tool switches over
automatically as soon as the strap tension has
been reached. The straps are welded and the
upper strap cut off.
– The tensioning process can be stopped at any time
and continued again. In order to release the strap
tension after the tensioning process, lift the rocker
lever (6/1) towards the handle.
– The strap tension can be adjusted on the operating
panel (see Chapter 5.6).
Tensioning – welding:
To perform welding before the strap has been tensioned,
fi
rst switch to operating mode „Manual“. However, the
tensioning button must be pressed once before welding.
– The digital display (8/1) indicates the cooling time of
the sealing. After
fi
nishing the friction welding, the
digital display counts backwards (3,2,1). Do not
remove the tool during this time!
Audible signal sounds once:
The sealing cycle is
fi
nished.
– After the audible signal sounds, raise the rocker lever
up to the handle.
– Swing the tool away from the strapping backwards and
to the right.
If the tool is removed too early, the
audible signal will sound several times
.
– Check the seal (refer to chapter 5.3).
Never transport or move packaged goods
with incorrectly welded seals.
If the tool is used in a dirty environment, it is
recommended that it should be cleaned daily. In
particular the tension wheel and the tooth plate should be
checked for damage and kept clean. This is best perfor-
med by blasting with compressed air (wear goggles).
