EN
There are two slots, one on each side of the handset.
• Attach the belt clip by inserting the sides of the belt clip
into the slots. Snap the ends of the belt clip into place.
No Display
• Check or replace the handset battery pack.
• Make sure the unit is connected to a non-switched electrical outlet. Disconnect the unit from the
plug and plug it in again.
• You must subscribe to Caller ID service from your local telephone company to receive CID
information.
Caller ID Error Message
• The unit displays this message if it detects anything other than valid Caller ID information
during the silent period after the first ring. This message indicates the presence of noise on the
line.
No dial tone
• Check or repeat installation steps:
• Make sure the wall base unit is correctly plugged into the electrical outlet.
Make sure power cords are connected to working electrical outlets.
Make sure the telephone line cord is connected to the telephone line jacks (at the wall base unit
and the wall).
• Disconnect the wall base unit from the wall telephone jack and connect another phone to the same
jack. If there is no dial tone in the second phone, the problem might be your wiring or local service.
• Handset or Kitchen Companion may be out of range from the wall base unit. Move closer to
wall base unit.
• Make sure the handset battery is properly charged (12 hours).
• Make sure the handset battery pack is correctly installed.
• Did the handset beep when you pressed the TALK/CALLBACK button? Did the display indicator
turn on? The battery may need to be charged.
CONNECTING THE BELT CLIP
slots for
belt clip
slots for
belt clip
CALLER ID
TROUBLESHOOTING TIPS
37
TELEPHONE
os6976-en1.p65
5/20/2005, 12:09 PM
40
Содержание OS6976
Страница 46: ......
Страница 94: ......
Страница 95: ......
Страница 96: ...2005 Oregon Scientific All rights reserved 086 003759 017 os6976 en1 p65 5 20 2005 12 09 PM 46...