Installation
The installation must be implemented with as little
resistance as possible in the ducts. Long flexible tubes
must be avoided. The caps must not be removed from any
unused inlets. The device is mounted to the wall or ceiling
with the four supplied screws and plugs.
Rear connections
At the rear of the suction plenum, an opening is prepared
for rear connections directly to the wall or the ceiling.
If these connections are used, the gap must be opened
with a Stanley knife. The plenum box can be sealed using
sealing tape (not included).
When using the Ø 160 mm connection under or behind the
unit, cut the adapter/pyramid away with a Stanley knife.
Mounting RF remote control (MVS-15RHB)
The remote control can be opened via the push button (see
figure 6), which is located on the underside. The wall frame
can then either be mounted with the 2 supplied screws and
plugs or be stuck in place. Please note: "UP" is marked on
the mounting frame, when mounting make sure that this is
at the top. Keep enough space free around the underside
so that the push button can be easily reached from below.
It is recommended that the remote control is installed in an
easily accessible place in the living room, kitchen or lavatory.
Never install the remote control near large metal objects,
and keep the remote control out of the reach of children.
4
Fig. 1 MVS-15 Connections
ø125 of ø160
ø125
ø125
ø125
ø125
195
195
344