-- 7- -
Automatically Diverting Calls
When connected directly to your phone socket (PSTN/Landline) or a line socket of a PBX system any calls
received will be automatically diverted to the programmed number of the FCT1500. We recommend a divert
delay of 10 seconds or more to allow time to intercept the call before it is diverted if necessary.
The FCT1500 will continue to call the number until the incoming call hangs up.
Three- way Calling
–
Only possible when connected to a PBX system that allows conference calling.
The FCT1500 when connected to an extension socket of a PBX system can be used to set up 3 way calls
(Conference Calls) between an extension, an incoming or outgoing external number and the FCT1500
programmed number.
Please refer to your PBX system user guide for setting up conference calls.
Calling into the FCT1500
(Mobile to Mobile call)
This is another cost saving feature of the FCT1500 when connected directly to your telephone line.
If you are away from the office and need to call in, calling from a mobile to landline is expensive, but the FCT1500
makes this a mobile to mobile call.
Using your mobile phone call the FCT1500 SIM card number, the phone connected to it will ring with a different
ring pattern alerting the office to a mobile incoming call.
If you want to use this service when the FCT1500 is connected to an extension of a PBX system, the same
applies but you will need to make sure a phone is connected to the FCT1500
–
see 4b of the installation guide
above. To answer the call, lift the handset of the telephone connected to the FCT1500 or use the PBX Systems
Call Pick up feature to take the call from any other phone.
Call Type Set up
Routing Calls over your FCT1500 or Land Line (PSTN)
The Factory default setting is for numbers starting with 00 (International) and 1 to 9 to go over the PSTN, this
makes up 10 default memories in the FCT1500.
All other calls will automatically go over the FCT1500 SIM Card
–
This will not affect the Divert functionality which
over rides all call types. This is for manual dialing only.
If you want any of these call types to go over the FCT1500 SIM Card you need to remove them from the factory
default list:
Command
Memory
No
Call Type
Notes of any changes
* # 21 #
01 *
1####
* # 21 #
02 *
2####
* # 21 #
03 *
3####
* # 21 #
04 *
4####
* # 21 #
05 *
5####
* # 21 #
06 *
6####
* # 21 #
07 *
7####
* # 21 #
08 *
8####
* # 21 #
09 *
9####
* # 21 #
10 *
00###
NB: For programming:
1. Call types must be given 5 digits so 00 become 00### and 6 become 6####
2. When entering each # you will hear 2 beeps
3. Hang up once programming is complete
–
your phone will ring once to confirm programming
