User manual
OPERATION INSTRUCTIONS
1. Modes selection: Press side button to change among high, low, off.
2. Battery indicator: When the light is turned on, the battery indicator will be
on to show the battery level.
-Green: over 70%
-Orange: 30%-70%
-Red: 10%-30%
-Flashing red: less than 10%
3. Safe lock function: Hold on the side switch for 5 seconds,the light will turn
off and turn into a state of safe lock.The side switch will be useless unless
unlocking it by a double press.(The light will flicker twice when you lock or
unlock the switch,the battery indicator will be green when at state of locked.)
4. Intelligent Over-Heat protection: This torch is specially designed for
underwater use. When used on land for too long, it might get too hot. But this
torch would drop down its output automatically once its temperature reaches
65
°
to avoid damage to the light due to overheat.
5. The total runtime will be extended significantly if the light is used
discontinuously.
Reason A: The batteries need to be replaced.
Solution: Replace batteries (Please confirm correct installation of + and -
terminals).
Reason B: The threads, PCB board contact or other contacts are dirty.
Solution: Clean the contact points with an alcohol soaked cotton swab.
If the methods above don't work, please contact the distributors and
refer to the warranty policy.
²
Tighten all the connections of the light before going underwater.
²
Please take out the batteries after each diving.
²
Please don't disassemble the sealed head, doing so may cause damage
to the flashlight and will void the warranty.
²
We recommend the use of high quality batteries. If the flashlight will not
be used for a long time, remove the batteries to avoid damage from
electrolyte leakage or battery explosion.
²
Please replace the O-rings if they are damaged after prolonged use and
regularly lubricate the o-rings with silicon grease so as to not erode the
rubber. Doing so will keep the flashlight properly sealed against water.
²
Please clean the contacts of your light from time to time, especially when
the light flickers or doesn't light up. There are probably several reasons for
a flickering or not working light:
Tel:+86-755-33560383 Fax:+86-755-29454989
Email: [email protected] www.orcatorch.com
Address: 7F, Building 6, Rundongsheng Industrial Park,
Gushu, Xixiang, Baoan, Shenzhen, China (518102)
ORCATORCH TECHNOLOGY LIMITED
USAGE AND MAINTENANCE
²
Please clean the surface of the light with fresh water and wipe it dry after
use in case of the seawater corrosiveness.
²
Do not drop or place the light on sand in case iron sand stick or go into
switch section or screw thread.
PRODUCT INTRODUCTION
OrcaTorch D530V is a professional underwater video light with Max 1200
lumens output. It has 140 degrees super wide floodlighting with no blind
angle for underwater photography. The light uses a titanium alloy side switch
that offers 2 lighting modes, which allows for easy operation underwater. The
LED indicator light located on the switch button also lets you know the
battery's remaining charge.
We will replace products afflicted with manufacturing defects within 30
days of purchase and repair a light free of charge within 12 months of
purchase if problems develop under normal use; if repair is required after
12 months from the date of purchase, we will charge for parts. The total
repair fee is dictated by the cost of the replaced materials.
PRODUCT WARRANTY
Warning
The flashlight is high intensity lighting device and capable of causing
eye damage, please avoid shining the light directly into the eyes.
Please register your OrcaTorch products through official website
www.orcatorch.com to get extra 1 year warranty.
Max
1200
Lumens
www.orcatorch.com
D530V
Notice: Stated data has been measured according to the international flashlight
test standards ANSI/NEMA FL1 using one OrcaTorch 18650 Li-ion battery (3.7V,
3400mah) under laboratory conditions. The parameters are approximate and
may vary between flashlights, batteries, and environments.
TECHNICAL PARAMETERS
Runtime
Waterproof
Working voltage
Dimension
Net weight
Accessories
3-8.4 V
142mm(Length) x 25.5mm(Diameter) x 35.5mm(Head)
145g(excluding battery)
One USB rechargeable 18650 Li-ion battery, lanyard, O-rings
Impact
Resistant
1.5m
under water 150m
1h24min
Output
Low
High
1200 Lumens
ANSI/NEMA FL1
290 Lumens
4h36min
PRODUCT FEATURES
Uses CREE LED, max 1200 lumens
Uses 1*18650 Li-ion rechargeable battery
140
°
super wide beam angle
Easy operation with side titanium alloy button switch
Battery indicator
Safe lock function, prevents mis-operation
Intelligent Over-Heat protection
Water pressure resistant construction ,depth rated to 150 meters
Reverse polarity protection, to protect from improper battery installation
Over-discharge protection function
Aircraft-grade high strength aluminum material
The latest diamond grade hard-anodized seawater-corrosion-resistance
finish
Two sides coated toughened glass with high water pressure resistance
under deep water
BATTERY REPLACEMENT
1. As shown in the figure, insert the battery with the anode side (+) toward
the light head.
2. Please do not reverse battery to avoid damage to the flashlight and
battery.
3. Please do not use battery with higher voltage than flashlight working
voltage.
4. Please do not use battery with damaged surface or deformation to avoid
short circuit, explosion, leakage, etc.
+
-
