ORBOT Pacific Floorcare MSE-19 ORB, Руководство по эксплуатации

Страница: 13 / 28

OPERATION
Attaching and Removing the Driver Plates
Put the machine base in an upright position,
sitting on the foot of the bumper.
Remove the driver plate by removing the four
countersink screws in the center of the plate
using an electric screwdriver.
Attach a driver plate to the machine base by
lining up the holes of the driver plate with the
appropriate threads of the bearing retainer
ring.
It is recommended to align the threads of the
bearing horizontally to the ground.
Put the 4 countersink screws through the holes
of the driver plate and first screw them into the
bearing retainer ring threads manually. Then,
tighten the screws with an electric screwdriver
WARNING
It is important to only use a # 3 Phillips head
screwdriver bit. Smaller bit sizes can damage
the screw heads and leave sharp edges,
which can tear or snag the pads. Damaged
screws can cause further damage.
• NOTE: Tighten the screws sufficiently to
avoid disengagement of the driver plate
from the machine base during operation.
To avoid stripping the screws, do NOT over
tighten. An electric screwdriver with a clutch
will ensure that stripping will NOT occur.
ACCESSORIES AND APPLICATIONS
WARNING
Never store the accessories in wet conditions.
Keep the accessories away from extreme heat
and from chemicals.
13