7 Operation
Operating instructions PS 4.5, PS 6.6
16
(12.06)
MT_PS 4.5, PS 6.6_BA_04_790048762_03.doc
orbitalum tools
gmbh
7.1
Mounting the clamping jaws to the vice
The
PS 4.5
is equipped with rotatable clamping jaws made from coated
aluminum cast. By rotating of the clamping jaws it is possible to process
small (
<
45 mm/1.772 inch) or large (> 45 mm/1.772 inch) tube diameters
(see „Scope of application“, chapter 3.2, p. 9).
When delivery of the PS 4.5 the clamping jaws are already mounted on the
PS
4.5, so that it can be started with processing of tubes
>
45 mm/1.772 inch.
With the standard clamping jaws of the
PS 6.6
made from coated aluminum cast
it is possible to process tubes with a outer diameter of > 50 mm/1.969 inch.
They are included in the standard scope of supply and are on delivery already
mounted on the PS 6.6. To cut tubes with a smaller outer diameter (min. 30 mm /
1.181 inch), special clamping jaws are necessary (see “Accessories”,
chapter 2.2.4, p. 7).
7.1.1
Disassembling clamping jaws from PS 4.5
1. Detach 2 wing screws (1) sidewards of the vice.
2. Remove the clamping jaws and turn by 180°.
3. Fasten the clamping jaws with 2 wing screws.
Note
1
1
180°
