WALL INSTALLATION
The weight of the Shower Core is approx. 30
kg. The surrounding structure must be able
to support the forces that will stress the at-
tachment points. Using the holes throughout
the back, the Mounting brackets are fixated
with screws hanging on the wall.
PREREQUISITES FOR INSTALLATION
Electrical Supply
Voltage and current rating:
220-240 V~ / 50 Hz / 16 A
Residual circuit breaker:
One per shower required. Having a rated residual tripping
current not exceeding 30 mA
Mains supply fixed cord:
Min. 2.5 mm
2
(rated for 16 A circuit)
Connectivity
Internet connection:
Private 2,4 GHz Wi-Fi network
Circuit breaker:
One per shower required
Plumbing / Water
Hot and Cold Water Inlet:
Separate hot/cold inlet required - 1/2” BSPP (G) pipe connec-
tion needed
Temperature of inlet water:
Cold: +4°C to +30°C
Hot: +55°C to +70°C
Water inlet flow:
Min. 9 litres/minute hot and cold
Water pressure:
Min. 3 bar/43,5 psi/0,3 MPa measured at the highest point of
installation
Max pressure 10 bar/ 145 psi / 1 MPa
Hardness of Water:
Required: 3°dH-10°dH
Preferred: 6°dH-10°dH or a total hardness of 110-180 mg Ca-
CO3/litres
Pre-installation
6
