Orbit Industries, Inc.
2100 S. Figueroa St. Los Angeles, CA 90007
Tel (213) 745-8884 Fax (213) 745-2015
www.orbitelectric.com
LFL3 - Series
Category:
INSTALLATION INSTRUCTIONS
WARNING:
All work must be performed by qualified electrician. Luminaire must be installed and grounded in
accordance with the National Electrical Code (NEC) and local codes. Failure to do so may result in serious
injury and/or damage to the luminaire.
WARNING:
Debris must be kept clear from top and interior of in-grade fixtures. Excessive heat could occur that
may create a fire hazard and/or harm the fixtures components. Specific attention must be made to never
install in-grade fixture in mulch, wood chips or other potentially ignitable materials. For installation in potentially
ignitable materials, such as mulch and wood chips, installer must use an above-grade mounted fixtures. Failure
to do so will void the warranty and may result in serious injury and/or damage the fixture and/or property.
SAFETY WARNING:
Luminaire can become very hot depending on the lamp wattage used. Lens and housing
around the lamp can become hot enough to blister hands. Particular care should be taken not to locate
luminaires where small children can reach them if high wattage lamps are used.
NOTE:
Save these instructions for future reference.
NOTE:
Illustrations are used for reference
purposes only; actual fixture may differ on
each luminaire.
NOTE:
LFL3 - Series
Operating Voltage: 120~277VAC
PRECAUTION:
This luminaire is designed to be mounted on a pole
or post up to 2” diameter only.
MOUNTING FOR POLE OR POST:
1. To prevent electrical shock, disconnect power
from electrical supply before installation or
service.
2. Check the pole or post size before start any
installation. The split fitter can be used up to
2” diameter only.
3. Attach luminaire leads first to line and observing
polarity, black to black, white to white and green to
ground by using wire nuts (not included).
4. Insert the luminaire Split Fitter to the pole or post.
5. Tighten the four bolts / screws of the split fitter
evenly.
6. To adjust luminaire aiming angle, un-tighten the
adjustable angle screw. Do not disengaged totally.
Hold luminaire at selected angle and tighten the
screw firmly.
7. Turn ON power and check for proper operation.
SLIP FITTER TYPE
Adjustable Angle Screw
Bolt / Screw
LED Fixture
Pole or Post
Slip Fitter
SLIP FITTER TYPE
