Orbit baby helix plus, Инструкция по эксплуатации

Страница: 16 / 32

8 – ENGLISH – Manual Text Booklet – Orbit Baby Helix Plus Upgrade Kit
Removing your old handlebars
⃞
Start with your stroller frame open and erect. Completely unscrew both thumbscrews
Ⓑ
under the
Orbit Baby Stroller G2 water bottle tray.
⃞
Remove the old water bottle tray by pulling up firmly. Remove the stroller strap.
⃞
Using the included Phillips screwdriver tool, remove the screw that holds the left water bottle
bushing and handlebar in place. Then remove the screw on the other side in the same manner.
Push down on the left handlebar button and pull up on the handlebar to remove it from the stroller
frame. Remove the right handlebar in the same manner.
⃞
Remove the thumbscrews by taking off the small snap rings that hold them in place. Insert the tip
of the included Phillips screwdriver tool or a ballpoint pen into the small openings in the snap ring
and lever outward.
⚠
WARNING
⚠
◦
Proper assembly is required. Check that handlebar is properly installed and fasteners are tight.
Installing your new handlebar
⃞
Remove the two loose Phillips screws in the bottom of the handlebar assembly. Install the new
handlebar assembly by sliding the water bottle tray
Ⓚ
onto the exposed aluminum handlebar
tubes. Push the water bottle tray down until it covers the square cross tube and cannot be pushed
down further.
⃞
Using the included Phillips screwdriver tool, install the two screws through the square cross tube
and thread them into the silver fittings in the handlebar assembly. Tighten completely.
⚠
WARNING
⚠
◦
Proper assembly is required. Check that wheel disks are properly installed and fasteners are
tight. Shake rear wheels after installation to ensure neither the disk nor the cap move or rattle.
Installing your wheel disks
⃞
Remove both rear wheels from the stroller frame by pulling down on the bent metal tab behind the
wheel and pulling the wheel outwards. Remove the three Phillips screws that are loosely fastened