BA 3500
12
and pudding powders. Dough hooks for the preparation of heavy yeast dough or short pastries. Also potato dough to
the dumpling and potato pancake preparation mixes one with it knead hooks easily and quickly. With the blending
rod, you will be able to blend in an easy way.
2. Inserting the beaters/dough hoods/blending rod
a) For dough hooks and beaters, the ones with washer can only be inserted into the big socket and the other one can
only be inserted into small socket.
b) For attach blending rod see the below figure for illustration. First pull the door upwards (Fig. 2) and then hold it in
the upper most position (Fig. 3) while turning in clockwise the blending rod.
Note: ensure beaters, dough hooks or blending rod are fully inserted into the correct sockets or your mixing results
may be affected.
Note: only one type accessories can be used one time.
USING HAND MIXER
1. With the speed selector in the beater eject position, plug the cord into power outlet.
2. Turn the Speed selector to your desired speed and begin mixing. The mixer run at highest speed when press turbo
button.
Tip: Always start mixing at slow speeds and increase the speed gradually to prevent ingredients splashing out of the
mixing bowl. When adding dry ingredients, use the lowest speed in order to prevent the snow storm effect.
3.
For the blending rod, the max operation time per time shall not exceed 1 minutes; for the mixer, the max
operation time per time shall not exceed 3 minutes, and minimum 10 minutes rest time must be maintained
between continuous two cycles
. When kneading yeast dough, suggest the speed selector is in 1 or 2 position then
set in top speed to achieve best results.
When mixing is complete, turn the speed selector to beater eject position and unplug the cord from power outlet.
4. Scrape the excess food particles from the beaters, blending rod or dough hooks by rubber or wooden spatula.
5. To remove the beaters/dough hooks, place fingers loosely around the spindles and turn speed selector to “0”
position then depress it firmly down.
Make sure the power cord is unplugged from the power outlet before
removing the beaters/dough hooks and blending rod.
USING YOUR BLENDING ROD
Before the first use, clean the blender according to the section of “cleaning”.
The time running unit without load can’t exceed 15s. Max operation duration under high speed per time cannot
exceed 1 minute, and 10 minutes rest time must be maintained at two consecutive cycles.
Important: Blades are very sharp, handle with care. Ensure that the hand-held blender is unplugged from the power
outlet before assembling or removing attachments.
1. First pull the door upwards and then hold it in the upper most position while turning in clockwise the blending rod
until tightened. For detaching blending rod, the ejector button is inactivated, just turning the blending rod in
anticlockwise direction and the door would be released automatically.
