Oracle SPARC T8-4, Руководство по установке

Страница: 60 / 92

Connect the Ethernet Network Cables
Connect the NET MGT port to your network switch or hub using a Category 5 (or
better) cable.
See “Rear Panel Components” on page 15 for connector locations.
The NET MGT port is not operational until you configure the network settings through
the SER MGT port as detailed in “Connect a Terminal or Emulator to the SER MGT
Port” on page 67 .
Note -
The NET MGT port is configured by default to retrieve network settings with DHCP and
to enable connections using SSH. You might need to modify these settings for your network.
Information related to changing these settings are in “Powering On the Server for the First
Time” on page 65 .
Related Information
■
“Server Overview” on page 12
■
“Rear Panel Components” on page 15
■
“Cabling Requirements” on page 51
■
“NET MGT Port” on page 55
■
“Assign a Static IP Address to the NET MGT Port” on page 79
Connect the Ethernet Network Cables
The server has four RJ-45 network connectors labeled NET 0, NET 1, NET 2, and NET 3. Use
these ports to connect the server to the network. The Ethernet interfaces operate at 100 Mbps,
1000 Mbps, and 10000 Mbps. See “Rear Panel Components” on page 15 for port locations.
Note -
The Oracle ILOM sideband management feature enables you to access the SP using one
of these Ethernet ports. Refer to the administration guide for your server for instructions.
Note -
To achieve 1 GbE network speeds, use Category 6 (or better) cables and network devices
that support 1000BASE-T networks.
1. Connect a Category 5 (or better) cable from your network switch or hub to
Ethernet Port 0 (NET 0) on the rear of the chassis.
2.
Connect Category 5 (or better) cables from your network switch or hub to the
remaining Ethernet ports (NET 1, NET 2, NET 3) as needed.
60 SPARC T8-4 Server Installation Guide • September 2017