Oracle Audio CD turntable, Руководство пользователя

Страница: 7 / 20

In the unlikely event that your Oracle suspension system
may need to be completely recalibrated please refer to
the caution on the preceeding page.
Make the Suspension Housing Sit Lower
Make the Suspension Housing Sit Higher
If the suspension housing is sitting to high as on this picture
• With one hand apply a
light down pressure to
the main chassis while
holding the suspension
housing
• Rotate the spring counter-clockwise by very small
increments until the suspension housing lightly
rests against the step on the gauge
If the suspension housing is sitting to low as on this picture
Do not allow the pliers to contact the aluminium parts since
this could damage the clear lacquer finish.
• Gently raise the
suspension
housing
with one
hand
• While holding the spring to prevent it from turning, rotate by very small increments
the suspension housing, couter-clockwise. This will move the spring further out of
the spring calibration sleeve thus making the suspension housing sit higher.
NOTE
IMPORTANT
•␣ When all suspension towers are fine tuned, install the suspension covers
Suspension Fine Tuning
To proceed with minor changes to the suspension
fine tuning, please read the following information.
• Using needle nose pliers, insert the tip
of the pliers near the end of the spring
and hold it firmly
5