Click
OK
to close the dialogue window.
4.3 Switch Settings
The XTEND-PKG-R DIP Switch allows users to configure “Serial Interface”. “Termination” and “Parity”
command parameter settings.
Figure 4-3 DIP-Switch Settings (Settings applied only when powering on)
For operation, change the hopping channel to 6.
4.4 Troubleshooting
Performing a range test will give an initial indication of the expected performance. If the loopback test
indicates that additional range may be required, ask the following questions about the installation:
Do I have clear RF line-of-sight?
If the Fresnel Zone is not clear of the ground or other obstructions, often the best way to improve range is to
raise the antennas higher off the ground to help transmit over vegetation or other obstacles.
Doc. No.: M00-20-7074 Rev.: 6
Page 39 of 43
Содержание M00-20-7074
