CR Series
Ref. 1830-SU-02-G
Page 13
Start of operation
1. To operate the CamRecord CR cameras, please install first the
camera driver as it is described in the driver user manual and the
CamRecord software (CamControl) as it is described in the
software user manual. Make sure, that your Laptop (PC) provides a
Gigabit Ethernet (GigE) interface.
2. When driver and software are already installed, the camera can be
operated directly:
Please connect the camera power supply to the power connector of
the CR camera and connect then the power supply to the 110-
240 Volt power source. The camera will operate immediately when
connection to the power supply is done. The green LED above the
power connector will glow green
Please connect then the GigE (Cat 6) cable to the Laptop (PC) and
to the connector of the camera.
Switch on the CamControl software on your Laptop (PC). The
software will start automatically and will connect the Laptop (PC) to
the camera.
3. To verify immediately the operation of the camera, the following
parameters in the “Setup-Menu” of the software can be selected:
Frame Format:
800 x 600 (CR450x2)
1280 x 1024 (CR600x2)
1280 x 1024 (CR1000x2)
512
x
512
(CR5000x2)
2304
x
1720
(CR
4000x2)
Frame Rate:
50 fps
Exposure Time:
1/50
Synchronisation:
internal
Select then “Video-Live” in the “Acquistion-Menu”. The camera
transfers now live-images to the monitor of the Laptop (PC).
To optimize now the image in a most simple way, please open or
close the iris and adjust the focus of the lens.
Remark:
When the communication from the Laptop (PC) to the camera fail, the
software will start first with a message box.