English
72
aDDITIonal InfoRmaTIon
Blurry double image
Select “PICTURE-->3D Display-->3D Enable-->Off” from the OSD to avoid normal 2D image is blurry
double image.
Two images, side-by-side format
Select “PICTURE-->3D Display-->3D Enable-->Side by Side” from the OSD for input signal is
HDMI 1.3 2D 1080i side-by-side.
Image does not display in 3D
Check if the battery of 3D glasses is drained.
Check if the 3D glasses is turned on.
When the input signal is HDMI 1.3 2D (1080i side-by-side half), select “PICTURE-->3D Display-->3D
Enable-->Side by Side”.
other problems
The projector stops responding to all controls
If possible, turn off the projector, then unplug the power cord and wait at least 20 seconds before
reconnecting power.
Lamp burns out or makes a popping sound
When the lamp reaches its end of life, it will burn out and may make a loud popping sound. If this
happens, the projector will not turn on until the lamp module has been replaced. To replace the lamp,
follow the procedures in the “Replacing the Lamp” section on page 57.
Remote control problems
If the remote control does not work
Check the operating angle of the remote control is pointed within 23’(7m) ±40° (horizontally) or 23’(7m)
±15° (vertically) to the IR receivers on the projector.
Make sure there are not any obstructions between the remote control and the projector. Move to within
10 m (32.8 ft) of the projector.
Make sure batteries are inserted correctly.
Replace batteries if they are exhausted.
Содержание WU1500
Страница 1: ...User manual DLP Projector...
Страница 77: ...www optoma com...