68 English
ADDITIONAL INFORMATION
Warning indicators
When the warning indicators (see below) light up or flash, the projector will automatically shutdown:
•
“Lamp” LED indicator is lit red and if “Power” indicator flashes red.
•
“Temp” LED indicator is lit red and if “Power” indicator flashes red. This indicates the projector has over
-
heated. Under normal conditions, the project can be switched back on.
•
“Temp” LED indicator flashes red and if “Power” indicator flashes red.
Unplug the power cord from the projector, wait for 30 seconds and try again. If the warning indicator light up or
flash, please contact your nearest service center for assistance.
LED lightning messages
Message
Power LED
Temp LED
Lamp LED
(Red)
(Blue)
(Red)
(Red)
Standby state
(Input power cord)
Steady light
Power on (Warming)
Flashing
(1 sec off / 1 sec on)
Power on and Lamp lighting
Steady light
Power off (Cooling)
Flashing
(0.5 sec off / 0.5 sec
on)
Back to red steady
light when cooling fan
turns off.
Error (LD over temp.)
Steady light
Error (LD failure)
Steady light
Error (Fan failure)
Flashing
Error (Over temp.)
Steady light
•
Power off:
Press power key again.
•
Temperature warning:
Warning
TEMPERATURE TOO HIGH
Please:
1. Make sure air in and outlets are not blocked.
2. Make sure the environment temperature is under 45 degree C.
If the problem persists in spite of the above.
Please contact a service center for repair.
Содержание W9PD7JF01VZ1
Страница 1: ...User s Manual DLP Projector...
Страница 75: ...English 75 ADDITIONAL INFORMATION Note Some commands are not supported it depends on models...
Страница 77: ...www optoma com...