Optoma ML330, Руководство пользователя

Страница: 18 / 53

English 18
USING THE PROJECTOR
Powering on / off the projector
OK
OK
or
Powering on
1. Connect one end of the power lead to the AC adapter and the AC adapter to the DC IN connector on
the projector.
2. Connect the other end of the power lead to the electrical outlet. When connected, the On/Standby LED
will turn red.
3. Connect the signal/source cable.
4. Turn on the projector by pressing the " " button either on the projector or the remote control.
5. A start up screen will display in approximately 5 seconds and the On/Standby LED will turn solid blue.
Note: During start up, the touch control panel LED will be fl ashing blue.
Powering off
1. Turn off the projector by pressing the " " button either on the projector or the remote control.
2. The following message will be displayed:
Power off?
PowerKey: OFF No operation: Cancel
3. Press the " " button again to confi rm, otherwise the message will disappear after 5 seconds. When
you press the " " button for the second time, the projector will shut down.
4. The cooling fans will continue to operate for about 5 seconds for the cooling cycle. During the cooling
cycle, the On/Standby LED is solid red. If you wish to turn the projector back on, you must wait until
the cooling cycle has fi nished and then simply press the " " button again to turn on the projector.
5. Disconnect the AC adapter from the projector and the power lead from the electrical outlet.
Selecting an input source
The projector enables you to connect various input sources using cable connections, wireless network, Bluetooth,
or simply plugging in a SD card. For connecting sources to the projector, please refer to page 14 .