opto engineering TCZR036S, Инструкция по эксплуатации

Страница: 7 / 10

V 1.1 - eng 7
5.1.3. Open the GUI and Load the XML configuration file
Open a browser and type 192.168.1.200 in the address bar. Now you are in the “Operation” web
page of the MTDV GUI.
Figure 3: MTDV GUI – Operation tab
Click the button “Import/Export XML” (top-right of the web page) and click “Browse XML file” to
select and load the XML file previously downloaded. If you use a multichannel device (i.e.
MTDV2CH-22A2, MTDV3CH-22A3, MTDV4CH-22A4) you can choose which channel to associate to
the zoom (see Figure 4).
The MTDV has 100 memory slots (from 0 to 99) to save motor positions. The XML file contains the
information of the 4 motor positions for the 4 different magnification of the lens. You can specify
the memory offset to save this information. For example, if you choose “0” motor positions are
saved into 0, 1, 2, and 3 memory slots. If you choose “21” motor positions are saved into 21, 22, 23,
and 24 memory slots. Click “Import XML” and your MTDV is configured for your TCZRS family
zoom lens. Please refresh the page to see the updated MTDV configuration.
5.1.4. Connect the TCZRS zoom lens
Switch off your MTDV1CH-22A2 motion controller by disconnecting the power connector. Connect
the TCZRS zoom lens using CBMT002 cable and power on the controller.
Wait a few seconds, then open a browser and type 192.168.1.200 in the address bar. Now you are
in the “Operation” web page of the MTDV GUI. At the bottom of the page there is a text box
named “Memory slot (0-99)”. Type in that box a number in the range you choose while importing
XML information (for example 0 ÷ 3 or 21 ÷ 24) and click “Load” button to load each position of
the TCZRS zoom lens.