A23.0910
www.optoedu.com
Page 7 of 14
Fig. 6
2-2-4
Assemble the Head
1)
Loosen the head lock-screw
①
fully with a M4 inner
hexagon spanner.
2)
Make the two tubes face forward, from a little rear
position of the center, insert the coattail interface on the
bottom of head into the hole of body with a little rear
inclined. Match the orientation groove
②
of the head
with the orientation pin
③
of the body, and then screw
down the lock screw
①
. (See Fig. 6)
2-2-5
Assemble the Eyepiece
1)
Take down the eyepiece tube cover
①
.
2)
Insert the eyepiece
③
into the eyepiece tube, until it
touches the bottom. Lock the eyepiece by the lock-screw
②
(See Fig. 7)
Fig. 7
Fig. 8
◎
Install or Remove the Reticle
1)
Unscrew the pressure ring from eyepiece (see Fig. 8).
2)
Clean the reticle, then install it into the pressure ring
with the scaled surface upward (see Fig. 8).
3)
Screw the pressure ring which is with reticle into the
eyepiece until tight enough.
4)
To remove the reticle, first unscrew the pressure ring
from eyepiece, then take down the reticle and keep it
with clean paper packed.
2-2-6
Assemble (Remove) the Worktable
1)
Place the worktable on the installation hole of the
base.
2)
To remove the worktable, use fingertip to press down
the worktable nearby the pillar edge (as the arrowhead
direction shown in Fig. 9), then the other end of
worktable will turn up. (See Fig. 9)
Fig. 9
Press
down
