A23.0910
www.optoedu.com
Page 6 of 14
2-2
Assembling Steps
Fig. 2
Fig. 3
Fig. 4
2-2-1
Assemble the Focusing Bracket Group
Loosen the lock knob
①
of the focusing bracket group,
insert the hole
②
of focusing bracket group into the
column
③
, until the focusing bracket group to the
lowest position. Then tighten the lock knob
①
to prevent
the microscope from turning.
◎
Slowly insert it, do not force too much.
◎
To avoid the microscope turnover, the focusing
bracket group must assemble on the same side to the
worktable of base group, as the left view of Fig. 3. If
assemble the focusing bracket group on the wrong side,
the microscope will turn over as the right view of Fig. 3.
2-2-2
Assemble the Microscope Body
1)
Remove the decorative cover
①
of the focus bracket
group, and loosen the M4 inner hexagon screw with a
M4 inner hexagon spanner. (See Fig. 4)
2)
Match the dovetail interface
③
of the microscope
body with the dovetail groove
②
of the focus bracket
group, and insert it from top to bottom as the direction
shown in the figure.
3)
Tighten the M4 inner hexagon screw on the focus
bracket group with a M4 inner hexagon spanner, then
put the decorative cover
①
back.
2-2-3
Assemble the Objective
1) Rotate the objective as the arrowhead direction shown
in the figure, and screw the objective
②
into the
objective installation screw hole
①
. (See Fig. 5)
Fig. 5
