OPTO 22 SNAP-PAC-S1, Руководство пользователя

Страница: 21 / 78

SNAP PAC S-Series User’s Guide 15
15
Chapter 2
2: Quick Start
Installing and Configuring the Controller
What You Will Need
• PC running Microsoft Windows 2000, XP, or Vista workstation operating system, with a 10/100
MB Ethernet interface, the TCP/IP protocol installed, and a valid IP address, on the same subnet
as the controller
• Crossover cable (for direct connection to the PC) or an available connection to a standard
10BASE-T or 100BASE-TX Ethernet network
• SNAP PAC S-series controller
• CD that came with the controller or PAC Project Professional CD (purchased separately)
• 8–32 VDC power supply (see “Power Supply Recommendations” on page 16 for specific
information and recommendations)
• Small flathead screwdriver
• One or more of the following, depending on your I/O system requirements:
– Opto 22 SNAP PAC I/O units on the same Ethernet network as the controller.
– For Wired+Wireless PACs, a wireless local area network (WLAN) and Wired+Wireless SNAP
PAC I/O units
– Opto 22 legacy SNAP Ethernet-based I/O units—SNAP Simple I/O, SNAP Ethernet I/O, or
SNAP Ultimate I/O units—on the same Ethernet network as the controller.
– Opto 22 RS-485 serial-based I/O units—SNAP PAC serial brains, serial B3000, SNAP-BRS,
B100/B200 brains, or mistic remote bricks (G4D16R, G4D32RS, G4A8R)—on a two-wire
RS-485 network.
Installing Software
In your CD-ROM drive, insert the CD that came with the SNAP PAC S-series controller. The installation
wizard should start automatically. If it doesn’t, use Windows Explorer to navigate to your CD-ROM
drive and then double-click setup.exe.