BWS350 System Installation, Operation & Maintenance
19
To Remove Tubing:
Press collet in to release grippers. While holding the collet
in, pull out on the tubing.
It may be necessary to use a partially open crescent wrench
or similar device to hold both sides of the collet in while
pulling the tubing out.
To Attach Tubing:
To ease insertion, moisten end of tubing with fresh
water or 3% hydrogen peroxide solution.
Push tubing straight in.
Resistance will be felt when the
tubing meets the O ring.
The outside of the tubing must be
free of knicks and gouges.
Cut tubing with a plastic tubing cutter or a
razor knife. Make a clean, square cut.
After cutting, make sure the end of the tube is
round. Correct any out of roundness that may have
occured in cutting the tubing.
Fitting Overview
Tubing Preparation
Fitting Body
Collet/Gripper
(Dark Gray)
Tube Stop
O-Ring
Keep pushing until the
resistance is overcome
and the tubing rests
against the stop.
1
3
2
Cutaway view of fitting and tubing
How to Use Our Push-to-Connect Fittings
High Level Switch Testing
Switch Test:
Float UP,
Processor OFF
Float DOWN,
Processor ON
