Three-Way Bass Reflex Car Speaker System
(120-1725) Wiring the Speakers Faxback Doc. # 38064
Connect two speakers to your auto sound system as shown.
NOTES:
If your autosound system has a front-to-rear fader, follow the
instructions in the audio component's manual for the correct speaker
connections.
To ensure proper phasing, match the speaker wires to the corresponding
red (+) or black (-) speaker terminals. Improper phasing can cause
poor bass response.
CAUTIONS:
Do not connect any of your speaker wires to chassis ground. Use all
four wires to connect the speakers to your vehicle's autosound system.
Do not connect four speakers to your car stereo/amplifier unless it is
designed for a four speaker connection. See your stereo/amplifier's
owner's manual for instructions.
ROUTING SPEAKER WIRE
Avoid routing speaker wire near moving parts or sharp edges. You can
usually route it along the wiring channel beneath the vehicle's door
facings by carefully removing the molding that holds the carpet in place.
After routing the speaker wire, replace the molding.
MOUNTING THE SPEAKERS
After you have connected the speakers and turned on your autosound system
to ensure that everything is working properly, turn off your autosound
system and mount the speakers.
1. Select a flat area (such as your car's rear deck) for the mounting
surface. The surface should be sturdy enough to support the weight of
the speakers.
2. Use the speaker cabinet's base as a template to mark the desired
