Optimum SW-0095, Руководство по эксплуатации

Страница: 12 / 14

12
SHORT CUTS TO PERFECT FLAT TOPS, CREW CUTS
• Always cut from the back of the neck to the crown, using
the longest attachment comb. Holding it flat against the head,
slowly move the clipper up through the hair.
• Use the same technique for the sides, cutting from the bottom
to the upper side of the head (Fig. 7).
• For the front to the crown, cut the hair against the direction in
which it grows. Then even it up with the sides (Fig. 8).
• For a flat top, use a flat comb, not the attachment comb. Just
cut hair on top of the head over it.
• To taper hair down to the neckline, use closer cutting
attachment combs. Comb hair and check for uneven spots and
outline sideburns and neckline (Fig. 9).
If a short tapered cut on the sides and back is desired, follow
the diagram below:
The four basic areas illustrated on the hair cutting guide are
your "road map" to easy do-it-yourself hair cutting.
MAINTENANCE
• Your clippers were carefully examined to ensure that the
blades were oiled and aligned before leaving our factory.
• Blades must be realigned if they have been removed for
cleaning or replacement.
• To realign the blades, simply match the upper and bottom
blades teeth up, point for point.
• (End of top blade teeth) should be approximately 1.2 mm
back from bottom blade.
• Compare your clipper blades with the sketch)
• If blade alignment is incorrect, add a few drops of oil to
the blades, turn clipper on for a few moments, turn off and
unplug. Loosen screws slightly and adjust. Tighten screws
after blade is aligned.
OIL
• To maintain your clipper in peak condition, the blades should
be oiled every few haircuts.