OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.0.1 dated 2018-01-31
Page 16
Translation of the original instructions
TM4010 | TM4010D
GB
T
M
4010_
T
M
4010D_G
B_1
.f
m
1.11
Personnel protective equipment
For certain work personal protective equipment is required.
Protect your face and your eyes: Wear a safety helmet with facial protection when perform-
ing work where your face and eyes are exposed to hazards.
Wear protective gloves when handling pieces with sharp edges.
Wear safety shoes when you assemble, disassemble or transport heavy components.
Use ear protection if the noise level (emission) in the workplace exceeds 80 dB (A).
Before starting work make sure that the required personal protective equipment is available
at the work place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause illness. It must be
cleaned after each use and at least once a week.
1.12
For your own safety during operation
We provide information about the specific dangers when working with and on the lathe in the
descriptions for these types of work.
WARNING!
Before activating the lathe ensure that this will neither endanger other persons nor
cause damage to equipment.
Avoid any unsafe work methods:
Avoid any unsafe work methods:
Make sure that your work does not endanger anyone.
Clamp the workpiece tightly before activating the lathe.
Observe the maximum lathe chuck opening.
Wear safety goggles.
Do not remove the turning chips by hand. Use a chip hook and / or a hand brush to remove
turning chips.
Clamp the turning tool at the correct height and with the least possible overhang.
Turn off the lathe before measuring the workpiece.
The instructions described in these operating instructions must be strictly observed during
assembly, operation, maintenance and repair.
Functional check
Equipment
Check
OK
Emergency-stop push
button
After activating the emergency stop mushroom button, the control voltage on
the lathe will shut off. The spindle continues to rotate for a while, depending on
the mass moment of inertia of the spindle and workpiece.
Positions switch
Lathe chuck protection
The spindle drive may switch on only when the lathe chuck protection is closed.
Positions switch
Protective cover of the
headstock
The spindle drive of the lathe must only be switch on if the protective cover of
the headstock is closed.
Date:
Checked by (signature):
