OPTIMUM
M A S C H I N E N - G E R M A N Y
Version 1.0.1 dated 2015-12-17
Page 61
Original operating instructions
MH25V
GB
3
Unpacking and connecting
INFORMATION
The milling machine is delivered pre-assembled.
3.1
Scope of delivery
Check the milling machine immediately after delivery for transport damage, missing parts and
loose locking bolts.
Compare the scope of delivery with the attached packing list.
3.2
Transport
WARNING!
Severe or fatal injuries may occur if parts of the machine tumble or fall down from the
forklift truck or from the transport vehicle. Follow the instructions and information on
the transport box.
WARNING!
The use of unstable lifting and load suspension equipment that might break under load
can cause severe or fatal injuries. Check that the lifting and load suspension gear has
sufficient load-bearing capacity and that it is in perfect condition. Observe the accident
prevention regulations issued by your Employers Liability Insurance Association or
other supervisory authorities applicable to your company. Fasten the loads properly.
Never walk under suspended loads!
3.3
Set-up and assembly
3.3.1 Installation site requirements
The workplace for operating, maintenance and repair must not be
restricted.
The master switch must be freely accessible.
The illumination of the workplace must be designed in such a manner that an illumination of
500 Lux is attained at the tool tip.
If this is not guaranteed with the normal installation site lighting, workplace lights (available as
an option) must be used.
Centres of gravity
Load suspension points
(Marking of the positions for the load suspension
gear)
Prescribed transport position
(Marking of the top surface)
Means of transport to be used
Weights
