Optimum 3346245, Руководство по эксплуатации

Страница: 28 / 120

Version 1.0.4 - 2020-07-31 28 Translation of the original instructions
MZ4S GB
MZ
4S
_G
B_3.
fm
INFORMATION
In order to attain good functionality and a high processing accuracy as well as a long
service life of the machine, the place of installation should fulfil certain criteria.
Please observe the following points:

The device must only be installed and operated in a dry and well-ventilated place.

Avoid places close to machines which cause chips or dust.

The installation site must be free from vibrations also at a distance of presses, planing
machines, etc.

The foundation must be suitable for the milling machine. Pay attention also to the load-bea-
ring capacity and evenness of the floor.

The ground must be prepared in such a way that any coolant used cannot penetrate into
the ground.

Any parts sticking out such as stops, handles, etc. have to be secured by measures taken
by the customer if necessary in order to avoid endangering persons.

Provide enough space for set-up and operating personnel and material transport.

Also bear in mind accessibility for installation and maintenance works.

Ensure adequate lighting is available (minimum value: 500 lux, measured at the tool tip). At
lower illumination intensities, additional illumination has to be ensured e.g. by means of a
separate workplace lamp.
INFORMATION
The main switch of the milling machine must be freely accessible.
3.6 Machine mounting
3.6.1 Anchor-free mounting
Provide a solid substructure at each support point of the levelling points between the foundation
and the machine foot or use adjustable feet (2) with adjusting screws (3) from the delivery.