Technical specification
Version 1.0.1 - 2020-8-10
10
Translation of original instruction
GU30
GB
GU30_
GB.
fm
2
Technical specification
3
Delivery, interdepartmental transport and unpacking
CAUTION!
Injuries caused by parts falling over or off a forklift, pallet truck or transport vehicle. Only
use means of transport that can carry the total weight and are suitable for it.
3.1
Notes on transport, installation and unpacking
Improper transport of individual devices and minor machines, unsecured devices and minor
machines stacked on top of each other or next to each other in packed or already unpacked
condition is accident-prone and can cause damage or malfunctions for which we do not grant
any liability or guarantee.
Transport the scope of delivery secured against shifting or tilting with a sufficiently dimen-
sioned industrial truck to the installation site.
3.1.1
General risks during internal transport
CAUTION: DANGER OF TIPPING!
The device may be lifted unsecured by a maximum of 2cm.
Employees must be outside the danger zone, the reach of loads. Warn employees and, if
necessary, advise employees of the hazard.
Act responsibly during transport and always consider the consequences. Refrain from daring
and risky actions.
Gradients and descents (e.g. driveways, ramps and the like) are particularly dangerous. If such
passages are unavoidable, special caution is required.
Before starting the transport check the transport route for possible danger points, unevenness
and disturbances as well as for sufficient strength and load capacity.
Danger points, unevenness and disturbance points must be inspected before transport. The
removal of danger spots, disturbances and unevenness at the time of transport by other
employees leads to considerable dangers.
Careful planning of internal transport is therefore essential.
Electrical connection
3x 400V ~50Hz ( 60 Hz )
Motor power
2.2 kW
Weight
83 kg
Speed ( 50 Hz ) [ rpm
]
1450
Speed ( 60 Hz ) [ rpm
]
1740
Grinding wheel [mm]
Ø 300 x 50
Grinding speed ( 50 Hz ) [ m/s ]
22
Grinding speed ( 60 Hz ) [ m/s ]
27
Suction connection
Ø 35 and Ø 50
Machine weight [kg]
50 kg
Shaft diameter [mm]
Ø25
Bore diameter of grinding wheel [mm]
Ø75
