
Operation
Version 1.0 - 2020-09-04
23
Translation of original instructions
DX17E
EN
D
X
17E
_GB_
4.
fm
4.3.1 Drilling
Insert and tighten the drill bit.
Clamp the workpiece.
Release emergency stop.
Close drill chuck protection.
Push Start.
Press Stop.
4.4
Removing the drill chuck from the MT2 spindle holding fixture
The drill chuck and the taper mandrel are loosened from the drill spindle by means of a drill
drift.
WARNING!
Only disassemble the drill chuck if the drilling machine is disconnected from the
electrical supply.
Switch off the drilling
machine on the master
switch or disconnect the
mains plug.
Move the drill sleeve
down.
Turn the drilling spindle
until the openings of the
sleeve and of the drilling
spindle are superimposed.
Loosen the taper mandrel
of the drill chuck with the
help of a drill drift.
Img.4-2:
Removal
4.5
Adjustment of the mechanical drilling depth
To adjust the mechanical drilling depth.
Pull out the drilling depth stop.
Turn the drill depth stop.
Push the drill depth stop back in.
Img.4-3:
Mechanical drill depth stop
Drill drift
Drill sleeve
Drill chuck
or drill bit
Mechanical dog
Содержание 3020168
Страница 1: ...EN Operating Manual Version 1 0 Bench drill Part no 3020168...
Страница 26: ...Ersatzteile Spare parts 26 DE EN drilling parts preface_DE GB fm...
Страница 38: ......