Optimum 3020168, Руководство по эксплуатации, Страница: 11 / 38

Safety
Version 1.0 - 2020-09-04 11 Translation of original instructions
DX17E EN
D
X
17E
_GB_
1.
fm
1.13 Safety during operation
WARNING!
Before switching on the drilling machine make sure that there are

no dangers generated for persons,

no objects are damaged.
Avoid any unsafe work methods:

Make sure that your operation does not create a safety hazard.

The rules specified in these operating instructions must be observed during assembly,
operation, maintenance and repair.

Do not work on the drilling machine if your concentration is reduced, for example, because
you are taking medication.

Observe the accident prevention regulations issued by your Employers Liability Insurance
Association or other supervisory authorities applicable to your company.

Inform the supervisor about all hazards or faults.

Stay on the drilling machine until the machine completely stopped moving.

Use the specified personal protective equipment. Ensure you wear close-fitting clothing
and, if necessary, a hairnet.

Do not use protective gloves when drilling.
1.14 Safety during maintenance
Inform the operators in good time of any maintenance and repair works.
Report all safety relevant changes and performance details of the drilling machine or their oper-
ational behavior. Any changes must be documented, the operating instructions updated and
machine operators instructed accordingly.
1.15 Disconnecting and securing the drilling machine
Switch off the drill with the main switch and lock it so it cannot be activated by unauthorised per-
sonnel or switched on by accident.
The main switch can be locked by removing the shift lever.
All machine parts as well as all dangerous voltages are switched off. Excepted are only the
positions which are marked with the adjoining pictogram.
1.16 Mechanical maintenance
Reinstall all protection and safety devices after any maintenance work once the work has been
completed.This includes:

covers,

safety instructions and warning signs,

grounding cables.
Check if they are working properly!
1.17 Electronics
Have the machine and/or the electric equipment checked regularly. Immediately eliminate all
defects such as loose connections, defective wires, etc.
Specify the inspection intervals for the machine in accordance with § 3 of the Industrial Safety
Regulation, document these and carry out an operational hazard analysis in accordance with §
6 of the Industrial Safety and Health Act.

Electrical connection on page 18