Optika Italy INSPECTION SYSTEMS Series, Инструкция по эксплуатации

Страница: 12 / 192

Page 12
F Fig. 7 ig. 7
F Fig. 8 ig. 8
F Fig. 9 ig. 9
② ③
④
9.1 Light intensity adjustment
1. Rotate the light adjustment ring
①
on the right side of the
microscope body. (Fig. 7)
As an alternative:
1. Move the mouse button on the upper left corner of the screen.
2. The Main Control Panel appears (see chapter 10.1 a).
3. Adjust the illumination using the Camera Control Panel of the
built-in software.
9.2 Coarse focus tension adjustment
1. To adjust the focusing tension, hold the left knob
②
and ro -
tate the right knob
③
. (Fig. 8)
• Clockwise rotation increases the tension while counter-
clockwise rotation loosens it.
• Adjust the focusing tension to appropriate position, to pre -
vent the microscope body dropping during observation, and
also make focusing stable.
9.3 Parfocality adjustment
1. Rotate the zoom adjustment ring
④
to the minimum magni -
fication. (Fig. 9)
2. While observing on the monitor, focus the specimen.
3. Rotate the zoom adjustment ring
④
to the maximum mag -
nification.
4. Observe the image on the monitor: if it is not clear, rotate the
focusing knob to make it sharp.
5. Return zoom adjustment ring to the minimum magnification.
Now parfocality adjustment should be set.
9.4 Focusing
Put the sample to be observed on the stand plate and focus the
sample using the focusing knobs.
• If necessary adjust the height of the microscope head along
the pillar: unlock the fixing knob ⑤ , move the microscope to
the desired height and lock the fixing knob ⑤ after setting the
height of the microscope. (Fig. 10)
• In order to prevent accidental lowering of the system
due to imperfect locking of the fixing knob, it is advis -
able to also use the drop prevention ring
⑥
.
9. Use of the microscope
F Fig. 10 ig. 10
⑤
⑥
①