Booster and EQ Mode Setting
Booster and EQ Mode is used extensions over 10 m (33 feet). By default, M5-
2C2 transmitter and receiver are set to
“BOOSTER” and “AUTO” respectively.
Under the default setting, M5-2C2 is optimized for the length from 10m
(33feet) to 40m (130feet). If you don
’t get a picture still or have noise, Booster
and EQ Mode Setting are required like the followings.
1. Start by having the source equipments connected by cables and
playing with your display on.
2. Set the transmitter to
“BOOSTER” by “BOOSTER” switch on the front
side of Uplink module. Check if the display is displayed normally.
3. If you don
’t get a picture still or have noise, set the receiver to
“MANUAL” using “EQ MODE” switch of Downlink module.
4. Start with the
“EQUALIZER” knob all the way counter clockwise and
slowly turn the knob clockwise until the display is shown normally.
Table - Recommended Setting with the Length
Tx
– Booster
Rx
– EQ Mode
Acceptable Length
Normal
Auto
1~10m
Booster
Auto
10~40m
Booster
Manual
40~50m
1-7 Booster and EQ Mode Setting
Troubleshooting
The display displays only black screen.
Check that all AC and DC plugs and jacks used by external power
supplies (both Opticis and others) are firmly connected.
Ensure that power LED lit ON.
Ensure that the Uplink and Downlink modules connected correctly to
the PC and display, respectively.
Check if the PC and display are powered on and properly booted.
Reset the M5-2C2-TR using Reset button on Uplink and Downlink
modules.
Test to make sure the modules are working normally with short CAT5
or CAT6 cable 5~10m. If you get the good video at the short length,
you have to set the correct booster and EQ mode as guided on page
1-6.
Screen is distorted or displays noises.
Reset the M5-2C2 using Reset button on Uplink and Downlink
modules.
Reset the system.
Test to make sure the modules are working normally with short CAT5
or CAT6 cable 5~10m. If you get the good video at the short length,
you have to set the correct booster and EQ mode as guided on page
1-6.
Maintenance
No special maintenance is required for this product. Ensure that this product
is stored or used in a benign environment free from liquid or dirt
contamination.
There are no user serviceable parts. Refer all service and repair issues to
Opticis or its authorized distributor.
Technical Support and Service
For commercial or general product support, contact your reseller. For
technical service, contact Opticis by email
or visit its
website at
www.opticis.com
.
1-8 Troubleshooting, Maintenance, Technical Support
