Figure 3
– Connection of Audio Cable to Uplink Module
You can select one of different 3 audio inputs - RCA, S/PDIF(coaxial) and
S/PDIF(optical) - using the switch of front panel. Audio input is changed by
the audio selection switch.
Figure 4
– Selection of Audio Input
Step 4
In the same way as above, connect the Downlink module to the display by
DVI copper cable and to the audio output equipments such as media receiver
or speaker by audio cable. The RS232 devices near the display can be
connected by RS232 copper cables also.
Figure 5
– Connection of Downlink Module
1-4 Installation (continued)
Installation
Important: Please use the installation procedure below. Improper, or no
operation may result if the start-up sequence is not correctly followed.
Step 1
Carefully unpack the contents of the shipping group.
Step 2
With system power turned
off
, connect the Uplink module to the DVI
receptacle of PC or other video source equipment by a DVI copper cable or a
HDMI to DVI cable. If necessary, connect the RS232 cable plugs to each D-
sub 9-pin connector on PC and Uplink module.
Figure 2
– Connection of DVI and RS232 Cable to Uplink Module
Step 3
Connect the Uplink module to the audio source equipment by audio cables
such as RCA, S/PDIF coaxial cable and S/PDIF optical fiber.
1-3 Installation
