Step 5
Remove the module dust covers and connect Transmitter and Receiver over
LC to LC single-mode fiber, such as Fig. 6. Ensure the LC connector is fully
engaged.
Figure 6
– Connection of one (1) LC single-mode fiber cable
Step 6
Connect the AC/DC power adapters to both of the Transmitter and Receiver
and make the device of source and the display power ON.
Figure 7
– Connection of AC/DC power adaptor
Notice:
Please DO NOT look directly into the LC receptacles of the
Transmitter box, while it is powered on, although this product is regulated
strictly enough to operate under the LASER Class I, classified by CDRH/FDA
for Eye Safety.
1-5 Installation (continued)
Switch Setting Check
Please check Table1. HDFX-100-TR Switch setting, Normal HDMI to HDMI setting
is as below;
Table1. HDFX-100-TR Switch setting
Transmitter
Receiver
S/W 1
ON
[No change]
MUST BE ON
S/W 1
ON
Master(point to point)
OFF
OFF
Slave (1:N)
S/W 2
ON
HDCP disable
S/W 2
ON
Display Output : DVI
OFF
HDCP enable
OFF
Display Output : HDMI
S/W 3
ON
Monitor EDID
S/W 3
ON
[No change]
MUST BE ON
OFF
STANDARD EDID
OFF
S/W 4
ON
[No change]
MUST BE ON
S/W 4
ON
OFF
OFF
Way to use Monitor EDID.
HDFX-100-TR initially use default EDID for user
’s convenience.
If default EDID works not properly, please try EDID copy direct.
When you plug the power cable to Transmitter, EDID copy starts.
Step 1
Change Transmitter switch 3 (turn off) such as
‘Figure 8’
Figure 8 - Transmitter Switch Setting Change
Step 2
Transmitter: Disconnect HDMI and Power cable and connect Optical cable.
Receiver: Plug the Power, Optical and HDMI cable
In this Step, Receiver and HDMI connected Sink (Monitor) should be turned ON.
Make sure Transmitter Power cable is unplugged.
1-6 Installation (continued)
1-6 Installation (continued)
